Application instructions are enclosed with each kit but on receipt of your kit you should first check in order to ascertain that nothing is missing. In the unlikely event that a part is missing please advise us immediately, preferably in writing.

Thoroughly clean and dry the area to be covered with water with a small amount of detergent and preferably when dry degrease using the chemical ISOPROPANOL please do not use Methylated Spirits because we have found that this leaves a barrier between the surface and the adhesive on the reverse side of the vinyl.

Without removing the backing paper place the chevrons in the correct place on the rear of the vehicle and adhere the sections using masking tape.

When you are satisfied that everything is in the right place remove the backing paper off a section and carefully press it firmly on the surface of the vehicle using the plastic applicator supplied. Continue carefully until each section has been applied. If you wish to reposition a section carefully lift the Yellow material remove it and reapply it in the correct position.

If you are very nervous at applying the material fill a small garden spray can with lightly soaped water and spry lightly the area to be covered and the adhesive on the rear of the chevron. You will then find that the material can be easily slid into the correct position. You must ensure that all of the excess water is squeezed out between the vinyl and the vehicle. The vehicle must be left for at least 24 hours to allow for all moisture to dry out; failure to do this will result in the chevrons blowing off should you encounter wind and rain.